Pin It

How to make a Placemat Purse

How to make a Placemat Purse

Materials Needed:

  • 1 Fabric Placemat
  • 1/2 yard of Lightweight Fabric for Lining
  • 1/2 yard of Fusible Craft Interfacing (optional)
  • Pair of Handbag Handles (wood, plastic, leather, etc.)


Transform a basic household placemat from a flat, two-dimensional table covering to a hip and imaginative fashion accessory. The wonderful thing about placemat purses is the sheer variety of materials available: ribbed cotton, vinyl, tapestry, microfiber, straw, faux leather, brocade, novelty weaves and more. Oval, rectangular and octagonal shapes create an instant variety of purse shapes to choose from.

Instructions:

Step 1. If the placemat requires a bit more body, cut fusible interfacing to the size of the placemat, less 1/2 ” all around. Center the interfacing over the wrong side of the placemat and fuse, following manufacturer’s directions.

Tip: If you want to add even more personality, you can embellish the placemat with appliqués, beads, embroidery or rhinestones. If you are sewing on your embellishments, the best time to do this is before attaching the lining, so all any stitching on the wrong side of the placemat will be covered by the lining.

Step 2. For handle tabs, cut four pieces of lining fabric, each measuring 3” long by 1 1/2” wide. Fold each piece in thirds, lengthwise; adjust the final width of the tabs to fit through handle rings. Stitch lengthwise through all thicknesses down the center of each tab.

Step 3. Slip a tab through each handle ring; with raw edges of the tabs even, stitch across the tabs 1/2” from raw edges.

figure

Step 4. Center each handle along the short sides of the placemat, with tabs against the wrong side of the placemat. Place tabs so that raw edges extend 1/2” in from edge of placemat. Stitch across tabs to attach them to placemat. Stitch again to reinforce.

Step 5. Cut lining fabric to the size of the placemat. Turn under 1/4” on all sides of the lining, and press in place.

Tip: To add a handy inside pocket or two, cut pocket(s) from the lining fabric, approximately 5” X 5” square. Turn under 1/2” on each side, and top stitch in place. Position the pocket on the right side of the lining as desired; sew along the sides and bottom of the pocket.

Step 6. Position the lining, right side up, over the wrong side of the placemat and covering extended edges of tabs. Stitch the lining to the placemat along all edges, close to the pressed edge of the lining. You can use either machine stitching or invisible hand stitches, depending on your preference.

Step 7-to Create a Purse with Squared-Off Corners: Fold placemat in half, with right sides together. Sew sides with a 5/8” seam allowance. To create the width at the bottom of the purse, flatten the bottom corners, centering the side seams. Turn handbag right-side-out, and you’re ready to go!

figure

Step 7 - to Create a Flat Purse with Pre-Bound Edges: For this style, use a placemat with pre-bound, finished edges. Fold placemat in half, with wrong sides together. Sew sides with a 1/2” to 5/8” seam allowance, depending on the width of the placemat binding, so that stitching is at the inner edge of the binding.

Tip: If desired, finish the purse with a closure of Velcro, a button and tab loop or handbag snap.



Gold Sequin Collar
Stay Connected


New subscribers receive a coupon for 15% off!


Deluxe Machines